|
GAI-Tronics 700-102 Page/Party Indoor Wall Station
For Division 2 and Non-Hazardous Areas, Noise-Canceling Microphone, Non-moveable
Hook-switch; Hearing Aid Compatible Handset; Available with Aux Jack Option for
Headset Use; 12 Watt Speaker Amplifier
|
General Information |
|
Manufacturer |
GAI-Tronics |
|
Manufacturer Part Number |
700-102 |
|
Product Name |
Page/Party Indoor Wall Station For Division 2 and
Non-Hazardous Areas |
|
Marketing Information |
Handset/Speaker Amplifier with page switch
in handset for one-hand operation is to operate from 90-140 VAC. 50 or
60 Hz. It shall consume 10 V.A., 4.5 W at zero signal, and 50 V.A., 27
W, at maximum signal. The unit shall operate in ambient temperatures
from -30ºC to +70ºC (-22ºF to +158ºF). The handset amplifier section
shall have an output level of 1.5 Vrms (nominal) into a 33 ohm load.
There shall be a 55 dB nominal voltage gain, an Automatic Gain Control
Circuit, and a frequency response of 250 to 4000 Hz, ± 1.5 dB.
Distortion shall be no greater than 1.5% maximum THD at 1000 Hz. The
input impedance shall be 100 ohms (nominal) at 1000 Hz. It shall also
include a gray ABS handset with a 10 ohm, pressure differential,
noise-canceling dynamic transmitter, a 130 ohm, high efficiency dynamic
receiver, and a pressbar page switch for one-hand operation. The
transmitter gain, receiver volume, and sidetone controls are adjusted
through access holes on the rear surface of the unit.
The speaker amplifier section shall have a push-pull, Class B, 12 watt
minimum output at 120 VAC nominal input and with taps for 8 or 16 ohm
speaker loads. There shall be 20 dB maximum voltage gain into an 8 ohm
load, and a frequency response of 250 to 4000 Hz +0, -3 dB reference to
1KHz. The distortion shall be no greater than 1% maximum THD at 12 watts
and 1000 Hz, with a full load to no load regulation of a 1.5 dB maximum
rise, and an input impedance of 50,000 ohms (nominal). The volume
control shall be concealed and adjusted through the access hole behind
the nameplate on the front panel of the unit.
The hookswitch mechanism shall be an electronic proximity detection
circuit utilizing a sealed relay to eliminate exposed contacts. The
shipping weight shall not exceed 6.8 lbs (3.1 kg). |
|
Features |
- For Division 2 and Non-Hazardous
Areas
- Hazardous Area Approvals: Listed
to UL, cUL, and Atex Standards
- Noise-Canceling Microphone
- Non-moveable Hook-switch
- Hearing Aid Compatible Handset
- Available with Aux Jack Option for
Headset Use
- 12 Watt Speaker Amplifier
|
A-20061120-1164-130-E
*This item is BRAND NEW -
not refurbished. It comes with all manufacturer supplied accessories, and full
manufacturer's USA warranty.
|
